Supply Of Jungle Boot;-1. Upper Shall Consist Of Polyester Viscose (pv) Fabric, Water-repellent As An Outer Layer And 100% Non- Woven Nylon (camarilla Type) Lining As Inner Layer. The Two Fabrics Shall Be Adhered Together With Flexible Adhesive And Polyurethane Foam Of 5 Mm Thickness. Colour-olive Green,colour Of Sole And Toe Cap-black (for All Other Boots),blend Composition Of Polyester Viscose Fabric Water Repellent-polyester-80% Viscose-remainder.binding Material Of Polyester Blended Fabric, Black Having Blend Composition Of Polyester-67%, Cotton -33% & Confirming To Is:15852-2009 For Colour Fastness To Light, Washing & Ph Value.in Socks- In Sock Each Boot Shall Be Provided With A Detachable 4.0 Mm + 1.0 Mm Thick Full In Sock Of Compressed Molded Rubber Having Instep Arch Support And Adequate Ribs For Grip Ad Comfort. The Outer Layer Of The Knock Hill Be Covered With Cambrelle Type Material In Black Color. Toe Cap &stiffener Well Struck Heat Activated Thermoplastic Toe Puff & Stiffeners Of Minimum Thickness 1.5 Mm & 2 Mm Respectively Shall Be Used.thread Polyester- Nil Lace Each Pair Of Boots Shall Be Provided With A Pair Of Nylon Black Laces Of Length160 +width 6 Cm. Thickness Of Sole In The Finished Condition, 1 Min. Thickness Of Sole 4mm 2. Cleat Height 2.5 Mm3. Thickness Of Sole When Measured From Outside With Side Wall Forepart 20mm. 4.thickness Of Sole When Measured At Waist From Outside With Side Wall(mm)16, 5. Thickness Of Sole When Measured At Heel From Outside With Side Wall(mm) (min)35.6. Mass The Mass Of One Pair Of Finished Boots Of Size 8 Shall Be 750 To 850 Gms With An Increase Or Decrease Of 50 Gms For Each Bigger Or Smaller Size Respectively. 7-marking The Outsole Of The Boot Must Be Embossed /engraved With The Manufacturers Name Or His Recognized Trade Mark, Size, Month And Year Of Manufacture.8- Packing Each Pair Of Boots Shall Be Packed In Individual Boxes To Prevent Damage.